Matrox FastNIC 10/100 10574-MT-0102 Guia de Instalação

Matrox FastNIC 10/100Single Port Fast Ethernet 100BaseTX NICPCI Network Interface CardInstallation Guide10574-MT-0102The Matrox FastNIC 10/100 is a hi

JRegulatory ComplianceFCC Compliance StatementWarningChanges or modifications to this unit not expressly approved by the party responsible for the com

4. Carefully insert the FastNIC card into the PCI expansion slot as shown in the following diagram:5. Secure the FastNIC card in place with the bolt t

• SCO UNIXNOTE:Installation instructions for Windows 95, Windows NT, and Novell NetWare (DOS client) are provided below. For other network operating s

3. Click on the Have Disk button:4. Insert the driver diskette into the PC’s floppy drive. Specify the directory a:\win95 and click OK:5. By default,

Windows NTTo install the software driver for the Windows NT operating system, please perform the following steps:1. Double-click on the following icon

4. Insert the driver diskette into the PC’s floppy drive. Specify the directory a:\winnt and click OK:5. By default, the Fast NIC is configured for Au

FUnderstanding the Status LightsGTroubleshootingA diagnostic utility is supplied with the FastNIC to assist you with troubleshooting.Diagnostic Utilit

SOLUTION #2:The device may require a cross-over or straight-through wire in order to connect to the other device. Refer to the instructions contained

ISpecificationsStandard IEEE802.3/802.3u 10BaseT/100BaseTXBus Interface 32 bit bus masterHardware Interrupts PCI INTABase I/O Addresses Assigned by BI