Matrox M.Key/100 Manual de Instalação descarregar pdf (Página 10)

Chapter1　Installing Windows Server 2003

Manual OS Installation

1.1.4 Installing Internal Options

Before starting installation of the OS, install internal options in the server. For the procedures, refer

to "Chapter 6 Installing Internal Options" in the "User's Guide".

■

Precautions on OS Installation

● When using an internal data cartridge drive unit

Before installing, be sure to remove a cable of a Internal Data Cartridge Drive from a server.

After installation has been completed, connect a cable once again.

● When using an internal hard disk unit bay conversion kit or a PRIMERGY SX35

Delete all of the current disk array configurations on the array controller which is connected to the

internal hard disk unit bay conversion kit or the PRIMERGY SX35.

Before deleting the disk array configurations, be sure to make backup copies of all the necessary

data, as the internal data will be lost by the deletion. After the OS installation, re-create disk

array configurations and restore from the backup data.

● When using an external storage devices, e.g. ETERNUS

Turn off the external storage device during the OS installation.

When the following optional devices are connected to the server, be sure to

read "Precautions on OS Installation" described below. Failure to observe the

cautions may cause the OS to be installed in unexpected media.

• Internal data cartridge drive unit

• Internal hard disk unit bay conversion kit

• PRIMERGY SX35

External storage devices, e.g. ETERNUS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Sem comentários

Matrox M.Key/100 Manual de Instalação Página 10