Matrox M.Key/100 Manual de Instalação descarregar pdf (Página 20)

Chapter2　Installing Windows Server 2008

Manual OS Installation

2.1.4 Installing Internal Options

Before starting installation of the OS, install internal options in the server. For the procedures, refer

to "Chapter 6 Installing Internal Options" in the "User's Guide".

■

Precautions on OS Installation

● When using an internal data cartridge drive unit

Before installing, be sure to remove a cable of a Internal Data Cartridge Drive from a server.

After installation has been completed, connect a cable once again.

● When using an internal hard disk unit bay conversion kit or a PRIMERGY SX35

Delete all of the current disk array configurations on the array controller which is connected to the

internal hard disk unit bay conversion kit or the PRIMERGY SX35.

Before deleting the disk array configurations, be sure to make backup copies of all the necessary

data, as the internal data will be lost by the deletion. After the OS installation, re-create disk

array configurations and restore from the backup data.

● When using an external storage devices, e.g. ETERNUS

Turn off the external storage device during the OS installation.

● When using a SATA hard disk.

When not doing array configuration, connecting more than 2 hard disks to a controller and install-

ing OS, remove the hard disk which isn't used from a server.

After completion, install it once again.

● For PRIMERGY RX600 S4

Install OS after it detaches it when the expansion card has already been installed from PCI slot 1

to 4.

And invalidate the LAN port of the I/O riser card according to the following procedure.

◆ When the following optional devices are connected to the server, be sure to

read "■Precautions on OS Installation" described below. Failure to observe

the cautions may cause the OS to be installed in unexpected media.

• Internal data cartridge drive unit

• Internal hard disk unit bay conversion kit

• PRIMERGY SX35

• External storage devices, e.g. ETERNUS

• When a SATA hard disk is used.

◆ Although the following comment may be made in your "User's Guide", the

notes in this section have priority.

"2.1.1 Installing Internal Options"

IMPORTANT: If an internal option device that must be installed after the OS

installation has been already installed, remove the device, install the OS, and

then reinstall the device."

◆ Confirm the following "Precautions on OS Installation" when you use

PRIMERGY RX600 S4.

Failure to observe the cautions may cause the OS to be able to install it

normally.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Comentários a estes Manuais

Sem comentários

Matrox M.Key/100 Manual de Instalação Página 20

Comentários a estes Manuais