Matrox PJ-4OLP Guia do Utilizador Página 7

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 6
Matrox TripleHead2Go – User Guide 7
Connection setup – TripleHead2Go
Digital Edition
This section describes how to connect up to 3 analog or digital monitors to your Matrox product.
Note:
While using the DVI input connector on your Matrox product, the highest display
resolutions are available only with graphics hardware that supports dual-link DVI. For
information on the capabilities of your graphics hardware, see its documentation. For
more information on your Matrox product, see “Product information, page 21.
Note:
To get the most out of your Matrox product, we recommend you use identical
monitors (that is, monitors that support the same settings such as display resolution and
refresh rate). For information on the settings your monitor supports, see your monitor
documentation.
WA R N I NG :
Don’t change monitor connections while your computer is turned on. While
your computer is turned on, it may be using monitor settings that are specific to the current
monitor connections.
Some
devices may be permanently damaged if incorrect settings are
used.
Note:
To co n n e c t a
digital
monitor (a
monitor that uses digital input, usually a
flat panel monitor) to your Matrox
product, your monitor must have a DVI
connector.
If you have an
analog
monitor (a monitor
that uses analog input) with a DVI
connector and you want to connect it to
an HD-15 connector, you’ll need a separate adapter. If this adapter isn’t included with your
monitor, contact your monitor vendor.
Some monitors with DVI connectors support both digital and analog input. If you’re using
one of these monitors with your Matrox product, make sure its configured to use the
correct type of input. For more information, see your monitor documentation.
DVI connector
(digital)
HD-15 connector
(analog)
DVI connector
(analog/digital)
Vista de página 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Comentários a estes Manuais

Sem comentários